unsolved Final mill depth

[xiaohh2000]

I want to dig 2 holes as shown in this DXF file, the depth of the left circle hole is 10mm, the depth of the 2nd circle is 20mm. I do not know why the attachment can not be uploaded, but I want to show that the depth of the hole is already specified by the DXF file.
But I found that Z final mill depth has to be set from the DXF2GCode, is it possible to use the depth in the DXF file?

 

[spicer]

Pls register.
Then you can post all files

 

[xiaohh2000]

I have uploaded all files, thanks for supporting. Files

百度网盘 请输入提取码

百度网盘为您提供文件的网络备份、同步和分享服务。空间大、速度快、安全稳固，支持教育网加速，支持手机端。注册使用百度网盘即可享受免费存储空间

pan.baidu.com

 

[xiaohh2000]

I have uploaded the files. Thank you

百度网盘 请输入提取码

百度网盘为您提供文件的网络备份、同步和分享服务。空间大、速度快、安全稳固，支持教育网加速，支持手机端。注册使用百度网盘即可享受免费存储空间

pan.baidu.com

 

[spicer]

Please at least run your question through the translator. No one here understands Asian!

Do you can upload to Filer.net or https://www.xup.in/ or direct here?

I understand nothing here:



Our @RudiS speaks japonese. Chinese is a "no-go" here. Sorry.

 

[spicer]

Our forum is for peoples (users, mankind).
Not for money!! Only for fans

 

[xhh]

Finally I can upload picture now, thanks.
In the following DXF file, there are 2 holes, the depth of the first is 10mm, the depth of the 2nd one is 20mm.
But DXF2Gcode does not recognize the depth specified in the DXF file (at least I do not know how to configure it), the depth has to be configured as shown in the attachment.

 

[chrisko]

Hello xhh,

As of now, the dxf2gcode tool does not recognize the depth parameter from dxf files. Consequently, you will need to adjust this setting within the tool itself.

Best regards,

Christian

 

[xhh]

Thanks for the fast reply, do you have any plan to implement that feature? It should be useful, otherwise, the operator has to specify for each component.
I'm reading the source code, so far I'm not sure I'm experienced enough to add that feature.

 

[chrisko]

If you have a detailed question about how or where to implement, I am open to offering support.

 

[chrisko]

Initially, I would examine the DXF specification to locate the depth parameter within the file and attempt to import it. If you possess the specification, I can assist and direct you to the section where you can implement it.